Daikin Inverter Error Code 00 represents normal status during standby or idle modes. Technicians must investigate further when the unit shows no cooling or heating despite this display.
The code alone does not confirm full system health. Sensor drift or board issues can hide behind the reading and reduce efficiency over time. Owners gain reliable performance by running targeted checks instead of assuming zero faults.
Daikin Inverter Code 00 Fault Patterns
Daikin units display code 00 when the main board registers no active faults in basic monitoring loops. This reading appears during power on sequences and after reset cycles. Owners often overlook secondary signals that point to partial failures in the inverter drive. A quick review of symptoms helps separate true normal operation from masked problems. The table below lists common patterns seen in field service.
| Symptom | Primary Suspect | Difficulty 1-5 |
|---|---|---|
| No cooling output | Compressor start relay | 3 |
| Intermittent fan speed | Outdoor thermistor drift | 2 |
| High power draw | Inverter board capacitor wear | 4 |
| Remote commands ignored | Control signal loss | 3 |
Identify Root Causes For Code 00
Code 00 stays visible when the control board detects no open circuits in primary safety loops. Actual faults develop from gradual component aging rather than sudden breaks. Capacitor degradation on the inverter board often allows basic status reporting while blocking full power modulation. Thermistor resistance shifts create similar effects without triggering higher error codes. Wiring corrosion at outdoor terminals adds resistance that the board interprets as acceptable until load increases.
Daikin Inverter Code 00 Component Checks
Start by powering down the unit and locking out the breaker. Remove the service panel on the outdoor unit next. Inspect all terminal screws for tightness and clean any oxidation from contact surfaces. Measure thermistor resistance at room temperature and compare against the manufacturer chart. Reapply power and command a cooling cycle through the remote. Monitor inverter output frequency on the service display during the first five minutes of operation.
Daikin Error 00 Outdoor Sensor Tests
Outdoor sensors feed temperature data that influences compressor speed decisions. Drift in these components allows code 00 to persist while actual capacity drops. Clean the sensor housings first to remove dirt buildup. Disconnect each sensor and test resistance values at two different ambient temperatures. Replace any sensor that falls outside the published tolerance range. Reconnect wiring and verify that the service menu shows updated readings before restoring normal operation.
Daikin Inverter Board DC Voltage Tests
The inverter board converts line power into variable frequency output for the compressor motor. Voltage irregularities here produce no code yet limit performance. Measure DC bus voltage at the marked test points with the unit running under load. Compare results to the specified range listed in the service manual. Check gate drive signals with an oscilloscope if basic voltage tests pass. Swap the board only after confirming all input power values remain stable.
Daikin Error 00 Remote Signal Checks
Remote signals reach the indoor unit through infrared or wired connections depending on the model. Weak transmission prevents mode changes even when code 00 shows. Replace the remote batteries first and point the unit directly at the receiver. Observe the indoor display for response confirmation. Test with a second remote if available to isolate the issue. Clean the receiver lens and confirm no physical obstructions block the path.
Daikin Code 00 Inverter Board Sourcing
Secure a new inverter board or sensor assembly from an authorized Daikin distributor when tests confirm failure. Match part numbers exactly to the unit data plate before purchase. Install the component following torque specifications for all fasteners. Run a full system test cycle after reassembly to confirm code 00 remains and performance returns to rated levels.
Hey, I’m Jake. I focus on cooling systems at Appliance Mastery, like fridges, freezers, and air conditioners.
I’ve worked in appliance repair for more than ten years and I’m certified through NASTeC. I’ve seen just about every fridge issue you can imagine.
My goal is to help you fix problems without stress. Whether it’s a freezer that won’t cool or an AC that keeps beeping, I’m here to walk you through it.