The F2 error code on a GE oven signals a broken temperature sensor or open circuit in its wiring. Most owners resolve the fault by testing the sensor resistance and installing a new probe when values fall outside specifications.
Technicians measure the component at room temperature first to confirm the diagnosis before any disassembly. This sequence prevents mistaken control board replacements that multiply repair costs.
Review GE Oven Fault Quick Look Table
The F2 code appears when the oven control detects resistance outside the expected range from the temperature sensor. Primary causes include a failed probe, damaged wiring, or loose connections at the harness. Owners should start diagnostics here to isolate the issue quickly rather than replacing expensive boards. The table below summarizes common indicators and repair difficulty for each suspect.
| Symptom | Primary Suspect | Difficulty 1-5 |
|---|---|---|
| F2 code at startup | Temperature sensor probe | 2 |
| Intermittent F2 during bake | Wiring harness damage | 3 |
| F2 with no heat | Control board connection | 4 |
Identify F2 Error Root Cause
A failed temperature sensor probe creates an open circuit that triggers the F2 code on GE ovens. The sensor changes resistance with temperature and the control board interprets any deviation as a fault. Wiring breaks near the oven cavity or at the connector also produce the same error. Checking these elements first avoids unnecessary part swaps.
Technicians measure resistance at ambient temperature to verify the probe. Normal readings fall between 1000 and 1100 ohms at 70 degrees Fahrenheit.
Values near zero or infinity confirm the sensor requires replacement. This test takes minutes and requires only a basic multimeter.
GE F2 Oven Sensor Resistance Test
Disconnect power to the oven at the breaker before any testing. Remove the oven racks and locate the temperature sensor probe at the rear interior wall. Disconnect the wiring harness from the probe terminals. Set the multimeter to ohms and touch the leads to the probe pins.
Record the resistance value and compare it against the specification chart for the model. Repeat the measurement after warming the probe slightly with a heat gun to check for change.
Stable incorrect readings point directly to a bad sensor. Reconnect the harness only after all tests finish.
Execute GE Oven Sensor Replacement
Order a compatible temperature sensor probe for the specific GE oven series. Remove the mounting screws that secure the old probe inside the cavity. Pull the probe forward and disconnect the wiring harness carefully to avoid damage. Insert the new probe through the same opening and secure it with the original screws.
Route the wiring harness back to its original position without pinching. Reconnect the terminals firmly until they seat fully.
Restore power at the breaker and run a test bake cycle to verify the F2 code clears. Monitor the oven for 30 minutes to confirm stable operation.
GE Oven F2 Board Harness Inspection
Inspect the harness plug at the control board for corrosion or bent pins after sensor replacement. Clean any oxidation with electrical contact cleaner and a soft brush. Reseat the connector fully to restore proper signal path. This step catches secondary faults that mimic a sensor failure.
Test the oven again after cleaning. Persistent codes after a new sensor installation require board level diagnosis. Most cases resolve without reaching this stage when the probe test was accurate.
GE Oven Calibration Cycle Temperature Check
Run a full calibration cycle on the GE oven after all repairs. Set the temperature to 350 degrees and verify the actual cavity temperature with a separate thermometer. Adjust the offset if the display differs by more than 25 degrees. This final check ensures the new sensor integrates correctly with the control system.
Hey, I’m Jake. I focus on cooling systems at Appliance Mastery, like fridges, freezers, and air conditioners.
I’ve worked in appliance repair for more than ten years and I’m certified through NASTeC. I’ve seen just about every fridge issue you can imagine.
My goal is to help you fix problems without stress. Whether it’s a freezer that won’t cool or an AC that keeps beeping, I’m here to walk you through it.