The GE 4 Device Universal Remote Code List supplies the exact codes needed to sync media gear in minutes. Users select the matching entry for their device brand then follow the entry sequence on the remote itself.
This method covers televisions, DVD players, cable boxes and audio receivers from common manufacturers. The list reduces programming time by replacing random searches with direct inputs. Keep the remote aimed at the target device during each test cycle to confirm acceptance.
Retrieve GE Remote Code Table
The master data table compiles codes by device category and manufacturer for immediate reference. This format supports the four device buttons on the GE remote without requiring separate manuals. Users scan the relevant section first to match their equipment brand and type. The table includes only verified three and four digit entries that activate standard functions. Preparation requires noting the brand name on each media component before any button presses begin.
| Device Type | Brand | Code |
|---|---|---|
| Television | Samsung | 0105 |
| Television | LG | 0004 |
| Television | Sony | 0128 |
| DVD Player | Panasonic | 0435 |
| DVD Player | Philips | 0503 |
| Cable Box | Comcast | 0031 |
| Audio Receiver | Yamaha | 0177 |
| Audio Receiver | Denon | 0112 |
GE Code Groups by Device Type
Top tier analysis shows that television codes dominate the list because they represent the most frequent pairing. Audio receiver entries follow closely due to their overlap with multiple device slots. DVD player codes tend toward shorter sequences that finish programming faster than cable box variants. Patterns emerge when brands share code families across similar hardware lines. Review the table rows for the primary device first to avoid conflicts during simultaneous setup.
GE Remote Code Entry and Testing Steps
Practical logistics begin with clearing the programming memory on the GE Remote. Press and hold the setup button until the indicator light stays on. Enter the three digit code from the table row that matches the target brand. Release the button and test the power function on the media gear. Repeat the sequence for each of the four device slots while keeping the remote pointed forward.
Clear prior codes before new entries.
Test volume and channel functions after power confirmation.
Switch device modes on the remote between each slot.
GE Remote Television Code Entry Steps
Television programming uses the first device slot on the GE Remote in most setups. The process requires the code from the master data table and steady aim at the screen. Users enter the digits within ten seconds of the indicator light activation. Success appears when the television powers off on command. Store the remote in a consistent location after all slots receive their codes to prevent accidental resets.
GE Codes for Yamaha Denon Receivers
Audio receiver sync follows the same entry pattern but targets the auxiliary slot. The code list provides dedicated rows for Yamaha and Denon models that control volume across connected speakers. Users switch the remote mode button before input to avoid overwriting television settings. Confirmation comes from audible feedback through the speakers once power cycles complete.
GE Remote Codes for Panasonic Philips DVDs
DVD player configuration occupies the third device slot and relies on shorter codes for quick acceptance. The table supplies entries for Panasonic and Philips units that handle play and menu navigation. Users test the open close function immediately after code entry to verify the link. Multiple DVD players in one room may require distinct codes from the same brand family to prevent overlap.
GE 4 Device Remote Testing Steps
Test all four device slots in sequence after final code entry. Cycle power on each media component to confirm independent control. Adjust volume levels across the audio receiver and television to check signal strength. Replace the remote batteries if any slot fails to respond after two attempts.
Hey, I’m Jake. I focus on cooling systems at Appliance Mastery, like fridges, freezers, and air conditioners.
I’ve worked in appliance repair for more than ten years and I’m certified through NASTeC. I’ve seen just about every fridge issue you can imagine.
My goal is to help you fix problems without stress. Whether it’s a freezer that won’t cool or an AC that keeps beeping, I’m here to walk you through it.