The reset button on a Frigidaire fridge is located behind the lower front grille on most models. Owners reach the button by removing the toe panel and pressing it for five seconds to clear electronic faults.
This position keeps the control accessible while protecting it from spills and daily use. Frigidaire places the button near the condenser area so a reset can restore temperature settings and error codes without interior disassembly. Checking the exact spot first prevents unnecessary panel removal on newer units.
Remove Lower Grille on Frigidaire Fridge
Frigidaire fridges position the reset button behind the toe grille to shield it from kitchen traffic. The grille clips or screws into place on the bottom front edge. Owners must clear any stored items from the floor area before starting work. This step exposes the condenser coils and the small reset button mounted on the control board housing. Proper access avoids damage to plastic clips during repeated service.
Phillips screwdriver secures side brackets on older units.
Flathead screwdriver pries retaining clips on Gallery series models.
Flashlight illuminates the dark space behind the grille.
Frigidaire Fridge Reset Safety Preparation Steps
Preparation reduces the chance of accidental damage during panel removal. Unplug the Frigidaire fridge from the wall outlet before any contact with internal components. Place a towel on the floor to catch falling screws or clips. Confirm the model number on the door edge to match the correct reset location in the service sheet. These actions protect both the appliance and the user from electrical contact.
Frigidaire Fridge Reset Button Hold Sequence
Locate the small black or white button near the condenser fan once the grille is off. Press and hold the button for five full seconds until the control panel lights flash. Release the button and wait thirty seconds for the board to reboot. Reinstall the grille and restore power to test temperature recovery. This sequence clears stored error codes on electronic control boards.
Frigidaire Gallery Reset Failure Causes
Gallery series units sometimes require a second press after the initial reboot cycle. The control board may retain a fault code if the condenser fan remains obstructed. Clean the coils with a coil brush before attempting another reset. Persistent codes after two attempts point to a failing thermistor rather than a simple software lock. Owners should record any displayed error numbers for further diagnosis.
Frigidaire Fridge Temperature Recovery Check
Monitor the fresh food and freezer sections for two hours following the reset. The Frigidaire fridge should return to preset temperatures within this window on working units. Note any continued flashing lights or unusual compressor cycling. These observations confirm whether the reset resolved the original issue or if deeper component failure exists.
Frigidaire Fridge Panel Test After Reset
Press each button on the interior control panel to confirm full function returns. The Frigidaire fridge display should accept new temperature settings without delay. Listen for the compressor engaging within five minutes of power restoration. Any delay beyond this point indicates the reset did not fully clear the board memory.
| Tool | Purpose | Replacement Cost Range |
|---|---|---|
| Phillips screwdriver | Remove side brackets | 8 to 15 dollars |
| Coil brush | Clean condenser fins | 6 to 12 dollars |
| Multimeter | Check thermistor resistance | 20 to 35 dollars |
Frigidaire Reset Button by Model Type
Different Frigidaire production years move the reset button slightly within the same general area. Side by side models place it closer to the left condenser bracket. Top freezer units often mount it directly above the fan motor. Checking the wiring diagram on the back of the unit confirms the exact pin location before pressing. This verification prevents pressing an unrelated test point on the board.
Hey, I’m Jake. I focus on cooling systems at Appliance Mastery, like fridges, freezers, and air conditioners.
I’ve worked in appliance repair for more than ten years and I’m certified through NASTeC. I’ve seen just about every fridge issue you can imagine.
My goal is to help you fix problems without stress. Whether it’s a freezer that won’t cool or an AC that keeps beeping, I’m here to walk you through it.